Very good service and support! Anycubic is Trustworthy company.
Great filament - will buy again. I’ve had very few failed prints using this filament in a Kobra S1. Used with a layer of Magigoo on a textured PEI plate. I preheat the plate at 90 degrees a few minutes before starting the print.
Coming from an Ender 3 this is an incredible improvement. Starting with the unboxing, the instructionswere very clear and setting up the Kobra X was easy as it could get. The calibrations after first time boot took a bit of time but afterwards it doesn't need to calibrate as much. The print plate is high quality and makes the prints stick to it very nicely, the print quality is incredible and so is the printing time. The only downside I've seen so far is the amount of waste with single filament prints, it purges 2 blobs after levelling the bed which wouldn't be needed for a single colour. Overall it's an incredible printer for the costs!
I got this machine to wash and cure several figures at once. The machine did this beautifully, and it's very easy to 'switch' between washing and curing, namely, easy to remove the washing bucket when you need to cure your prints.
The courier service provided a reliable and secure delivery experience. The package arrived within the expected timeframe and was accompanied by clear and adequate shipment information throughout the process. Upon delivery, there was no visible external damage to the package, indicating proper handling during transport.
While the product appears to be in good condition upon initial inspection, its full verification will be possible only after installation. Overall, the service met expectations and can be considered satisfactory.